Factory-direct-hardware Hansgrohe 10406001 Axor Starck X Manuale Utente

Installation Instructions / WarrantyStarck X1040600190573801-00 07/2005

10Cleaning Recommendation for Hansgrohe ProductsModern faucetry and shower products utilize a combination of materials to comply with the needs of the

11THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:A. Conditions, malfunctions or damage not resulting from defects in material or workma

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.com

2Starck X Free-Standing Tub Filler10406001Technical SpecificationMaximum incoming water pressure 145 psiRecommended water pressure 14.5 - 72 psiReco

3InstallationIf installing with Duravit Starck X tub, please see the instructions starting on page 5.• Cut the plaster shield on the rough-in 3/8&quo

4• Seal the floor around the plaster shield with a waterproof sealant compatible with the floor surface. Lower the escutcheon to the floor• Push th

5Installation with Duravit Starck X TubThere must be a minimum 1 1/8” air gap between the tub filler and the top of the tub. If the air gap is not at

6• Place the tub escutcheon over the end of the tub filler.• Install the tub.• Install the tub filler to the rough. Slide the escutcheon and the t

7• Lower the tub escutcheon and escutcheon to the floor• Push the housing over the top of the tub filler. Tighten the nuts.• Install a black rubbe

8• Remove the handle screw. Pull the green high temperature limit stop straight off the cartridge.• Reinstall the high temperature limit stop so th

9Replacement Parts1 handle 104900001.1 screw cover 963380002 flange 963950003 nut 964610004 cartridge 927300005 spray former 974670006 di